This type of tipper is suitable for the transportation of the scrap materials.
The dimensions of the tipper body depends on the vehicle chassis measurements.
For different applications, please fill the request form.
The recommended volumes for the 6x2 chassis vehicles are 22 m3, 24 m3 and 26 m3
The recommended volumes for the 8x2 chassis vehicles are 28 m3, 30 m3 and 32 m3
8 mm thickness made of ST 44 steel, U-construction.
Inner reinforcement 6 mm. thickness made of ST 44 steel.
Torsion cross-members on the rear of the chassis.
The rear rotative arm made of 1040 hardness steel and the diameter is 85 mm.
Body : Hardox 450 (SSAB)
Floor thickness : 5 mm HARDOX 450
Side walls thickness : 4 mm HARDOX 450
Front Wall thickness : 4 mm HARDOX 450
Tailgate thickness : 4 mm HARDOX 450
Shelter thickness : 4 mm ST 37 steel sheet
The operating system of the tailgate is manual. Side opening.
Four satges heavy duty cold-drawn telescopic cylinder.
Hydraulic oil tank capacity: 110 lt.
Dual speed downloading valve, limit-check security valve.
35x85 DPA gear pump
Tailgate pistons: Special design and production from the high volume pipe.
PTO: original, mounted on the vehicle
Before the painting, the body is washed with special chemicals to purify the waste materials and cleaned by sand blasting method.
After the pasting on the necessary surfaces of the body, the two-coat epoxy primer and two-coat water-based paint is applicated on the body.
All painting applications are made in the painting cabin.
Mud guards above the rear axles. (steel)
Mud flaps with Arslan Damper logo
Tool box (steel)
Hooks welding on the side-front walls and tailgate for the tarpaulin
Reflector on the tailgate.
Ladder on the right side.